Explore the full lineup of INFINITI logo for SUVs, crossovers, sedans, and coupes. Looking for infiniti car logo? Replace directly the original infiniti logo lights? This product is specially designed for car modification enthusiasts, daytime car lights do not shine, and the original car standard no difference, when the night license plate lights open after the LED lights are also lit, so that the car marked The night becomes dazzling, very rich sense of the future of science and technology, highlight your car's noble descent.
* Voltage:12V
* Lamp Type: LED
* Type: Car Front logo light
* Warranty: 6 months warranty
* Color: White,Red,Ice Blue, RGB
* Power:2W
* Lifetime:50,000 hrs
Control APP: LED LAMP
Installation instructions:
1, Remove the old logo,
2, And then install the new logo light with 3M glue and clips, press it tightly, Align the buckle and push it in, press it tightly,
3, Connect the wires, the red wire is connected to the daytime running lights, and the black wire is connected to any iron.
2018 Q50 Specification
1, Net standard size: 19 × 9.5 × 5.8cm. Outer packing size: 22.7 × 14 × 7.5cm.
2, Trailer circuit board power: 3W.
3, Board wiring harness length: 1.2M, negative harness length: 0.6M.
4, Color : White /RGB available
2014-2017 Q50 Q50L Q50S Specification
1, Net standard size: 19 × 9.5 × 5.8cm. Outer packing size: 22.7 × 14 × 7.5cm.
2, Trailer circuit board power: 3W.
3, Board wiring harness length: 1.2M, negative harness length: 0.6M.
4, Color : Red, White , Blue available
2010-2013 G37 sedan
2010-2013 G25
2007-2009 G35 Specification
1,Product size : 16*7.5*5cm .
2, Trailer circuit board power: 3W.
3, Board wiring harness length: 1.2M, negative harness length: 0.6M.
4, Color : White available
2018-2021 QX50 SUV
1, Product size : 26.5*15*7cm .
2, Trailer circuit board power: 3W.
3, Board wiring harness length: 1.2M, negative harness length: 0.6M.
4, Color : Red, White , Blue available
Kindly attention , Please download the app name like the following photo
Installation instructions:
1.Put a towel next to the car box, with a flat head screwdriver pry the car logo, shop towel is to prevent scratches the body
2. Note that the first double-sided adhesive stripping the body, pry when the force is moderate, do not be too fierce, little by little, slowly pry down, clean the car and the body of the double-sided adhesive.
3. Use a Phillips screwdriver to remove the inside of the box, pay attention to some places have a clip, be careful to remove the noise board can see a variety of lines.
4. Now come to install the car lights, car lights power line through one of the car positioning hole, wear the inside of the car to tear off the side of the standard single-sided plastic, while pulling the side of the car lights to the car body, pressure tight.
5. car lights installed, and now connected to power. Car lights to be connected to the license plate after the lights power, so when the lights opened when the lights will also open the lights
6. First pull out the plug, positive and negative stripping a hole, exposing the wire core, according to the red on the red, black on the black line, do not forget to use insulating tape wrapped, and finally re-plug the plug back! Replace the rear cover insulation board.
